Simple Loop Instructions

Simple loops are commonly used for earrings or rosary chains as they are quick to make.

Simple loop instructions

Start with one headpin and two accent beads. You will need round nose pliers and a wire cutter.

Simple loop instructions

Stack the beads on the headpin.

Simple loop instructions

With flat nose pliers or your fingers, bend the wire directly above the bead into a 90° angle.

Simple loop instructions

Trim off the excess wire, leaving about 1/2".

Simple loop instructions

With the round nose pliers, grip at the very end of the wire.

Simple loop instructions

Slowly roll the pliers towards the beads, gripping the wire.

Simple loop instructions

Continue to roll the pliers, adjusting your grip if necessary, until the loop is formed.

Simple loop instructions

To attach an earwire, open the loop to the side with flat nose pliers and insert the earwire.


Try this simple loop project: